Monthly Archive:: February 2018
First roller done but it’s got a .002” taper so tomorrow’s task is lathe leveling.
![](http://steampunkworkshop.com/wp-content/uploads/2018/02/1519872091-685x275.jpg)
First roller done but it’s got a .002” taper so tomorrow’s task is lathe leveling.
Re-learning the lathe after 15 years without one.
![](http://steampunkworkshop.com/wp-content/uploads/2018/02/1519780832-685x275.jpg)
Re-learning the lathe after 15 years without one.
260 Pound DIY Anvil
![](http://steampunkworkshop.com/wp-content/uploads/2016/08/1471216833-685x275.jpg)
I built a 260 pound anvil from some scrap steel plate. The top plate was hardened in superquench and the horn was CNC milled on my Bridgeport Series II.
Meet Geordi The Forge!
![](http://steampunkworkshop.com/wp-content/uploads/2018/01/1515016753-685x275.jpg)
I built a coal forge from the remnants of an old Burnham oil furnace and a bunch of other junk I found at the town dump.
New project underway!
![](http://steampunkworkshop.com/wp-content/uploads/2018/02/1519608148-685x275.jpg)
New project underway!
The #ratwelder – Part 5 in the DIY Welder Series!
![](http://steampunkworkshop.com/wp-content/uploads/2018/02/snapshot3-685x275.png)
The latest episode in the homemade welder series wherein I complete an enclosure for the #ratwelder so I can store it outside without having to put a tarp over it.
Finished the body for the! The louvers look too nice though, debating whether to shoot them in red primer or just let them age naturally outside.
![](http://steampunkworkshop.com/wp-content/uploads/2018/02/1518384300-685x275.jpg)
Finished the body for the #ratwelder! The louvers look too nice though, debating whether to shoot them in red primer or just let them age naturally outside.